LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Volt >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Diagnostic Information and Procedures >> DTC C0914 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B119 Multi-axis Acceleration Sensor.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 10 Ω between the low reference circuit terminal 6 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K17 EBCM.
  3. Ignition ON, test for B+ between the ignition circuit terminal 5 and ground.
    • If less than the specified range, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K17 EBCM.
  4. If the circuits test normal, replace the B119 Multi-axis Acceleration Sensor.
scientia non olet · About LEMON Manuals