LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Volt >> Repair and Diagnosis (Single Page) >> Electrical >> Charging Systems >> Plug-In Charging >> Diagnostic Information and Procedures >> DTC P0D2B or P0D2C >> Circuit/System Testing >> LED Circuit Testing

LED Circuit Testing

  1. Cordset disconnected, disable the vehicle high voltage. Refer to High Voltage Disabling . Disconnect the X1 harness connector at the P36 battery state of charge indicator. Test for less than 1.0 V between the following control terminals and ground:
    • Terminal A
    • Terminal B
    • If greater than the specified range, test the appropriate control circuit for a short to voltage. If all circuits tests normal replace the K114B hybrid powertrain control module 2.
  2. If all circuits test normal, replace the P36 battery state of charge indicator.
scientia non olet · About LEMON Manuals