Circuit/System Verification
WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
On the scan tool, the powertrain relay is referred to as the engine controls ignition relay.
- If DTC P0685 or P0690 is set, diagnose that DTC first.
- Ignition ON, observe the scan tool Ignition 1 Voltage signal and the Engine Controls Ignition Relay Feedback signal parameters. There should be no more than 3 V difference between the two parameters.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.