LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Fixed And MOVEABLE Windows System) >> Repair Instructions >> Rear Side Door Window Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Glass and Sheet Metal Handling Warning
  1. Lower the window all the way down.
  2. Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement
  3. Remove the rear side door garnish molding. Refer to Rear Side Door Window Garnish Molding Replacement
  4. Remove the rear side door water deflector.
  5. Remove the rear side door window inner sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement 
  6. Remove the rear side door window belt reveal molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement 
  7. Connect the rear side door trim panel electrical connector.
  8. Run the window to the fully up position.
  9. Tape the window in the up position.
  10. Loosen rear side door front window run channel bolt.
  11. Loosen the window regulator guide nuts 4 revolutions.
  12. Using the power window switch, lower the window regulator to the fully down position.
  13. Remove the tape.
  14. Slide the window down past the window regulator guides and out of the front window run channel.
    15. Fig 1: Removing & Installing Rear Door Window
    GM758774Courtesy of GENERAL MOTORS CORP.
  15. Lift the rear side door window out of the door.
scientia non olet · About LEMON Manuals