LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive and Negative Cable Replacement (LF1) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Ground Harness Wire Terminal & Negative Battery Clamp
    GM2232745Courtesy of GENERAL MOTORS CORP.
  1. Remove the ground harness wire terminal on the negative battery clamp.
  2. Disconnect the current sensor from the engine harness.
  3. Remove the negative battery cable clamp (1) and the left front radiator support ground terminal (2).
    4. Fig 2: Identifying Battery Fuse Block Cover
    GM2232755Courtesy of GENERAL MOTORS CORP.
  4. Remove the battery fuse block cover (1).
  5. Remove the battery positive nut (2) from battery fuse block and detach retainer (3) from the battery tray.
    6. Fig 3: Identifying Battery Cables, Generator, Starter & Connectors
    GM2232752Courtesy of GENERAL MOTORS CORP.
  6. Remove the nut (1) from underneath the protective boot behind the generator.
  7. Remove the battery positive cable terminal from the generator.
  8. Remove the starter solenoid nut (2) and battery positive cable terminal from the starter solenoid.
  9. Remove the negative battery cable bolt (3) and terminal from the back of the left cylinder head.
  10. Remove the harness retainer band clip nut (4).
  11. Remove the harness retainer band clip bolt (5).
    12. NOTE: Observe how the battery positive and negative cable was routed within the engine compartment.
  12. Remove the battery positive and negative cable (6).
scientia non olet · About LEMON Manuals