LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> RV Cutaway 6.6 L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Glow Plug Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Glow Plug Control Module Bracket
    GM1862083Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Position the glow plug control module (2).
  2. Install the glow plug control module bolts (1) and tighten to 10 N.m (89 lb in) .
    3. Fig 2: Positive Battery Cable
    GM1862082Courtesy of GENERAL MOTORS CORP.
  3. Connect the positive battery cable (1) to the glow plug control module.
    4. Fig 3: Negative Battery Cable
    GM1862080Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the glow plug control module.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. If a NEW glow plug control module was installed, program the module. Refer to Control Module References .
  7. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals