Initialization Sequence
WARNING: This page is about a different car, the 2010 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
The electronic brake control module (EBCM) performs 1 initialization test each ignition cycle. The initialization of the EBCM occurs when 1 set of the following conditions occur:
- The EBCM detects that there is a minimum of 500 RPM from the engine control module (ECM) via a serial data message.
- The brake pedal is not applied.
OR
- The vehicle speed is greater than 16 km/h (10 mph).
- The brake pedal is applied.