LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knuckle to the vehicle.
  2. Install the bolts and nuts attaching the strut to the knuckle.

    Tighten:  Tighten the strut to knuckle bolts to 130 N.m (96 lb ft).

    Fig 1: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  4. Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Lower the vehicle.
  7. Inspect the front wheel alignment and adjust, if necessary. Refer to Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals