Digital Radio Receiver Replacement

WARNING: This page is about a different car, the 2010 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the right rear compartment trim. Refer to Rear Compartment Side Trim Replacement - Right Side .
1	Digital Radio Receiver Bracket Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tip: Disconnect the antenna and electrical connectors from the module. Tighten: 3.5 N.m (31 lb in)
2	Digital Radio Receiver Assembly Tip: Remove the nuts that retain the receiver to the bracket. If a replacement receiver is installed, perform the Digital Radio Receiver Setup. Refer to Control Module References . Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed. Tighten: 5 N.m (44 lb in)

Callout

Component Name

Preliminary Procedure:
Remove the right rear compartment trim. Refer to Rear Compartment Side Trim Replacement - Right Side .

Digital Radio Receiver Bracket Nut (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tip: Disconnect the antenna and electrical connectors from the module.

Tighten: 3.5 N.m (31 lb in)

Digital Radio Receiver Assembly
Tip:

Remove the nuts that retain the receiver to the bracket.
If a replacement receiver is installed, perform the Digital Radio Receiver Setup. Refer to Control Module References .
Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed.

Tighten: 5 N.m (44 lb in)