LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> HHR LT, 2.2 W, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Current Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Battery Current Sensor
    GM1631638Courtesy of GENERAL MOTORS COMPANY
  1. Install the battery current sensor by passing the ground end of the negative battery cable through the sensor.
    2. Fig 2: Negative Battery Cable
    GM1631636Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Ensure the battery current sensor is installed in the previous location on the negative battery cable.

  2. Fasten the battery current sensor with electrical tape to the negative battery cable.
  3. Install the negative battery cable to the battery. Refer to Battery Negative Cable Replacement .
scientia non olet · About LEMON Manuals