LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> HHR LS, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission - M86 >> Diagnostic Information and Procedures >> DTC P0806 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the CPP sensor.
  2. Ignition ON, observe the scan tool CPP sensor voltage parameter for 0.1 volt.
    • If the voltage is below the specified value, replace the CPP sensor.
    • If the voltage is above the specified value, replace the ECM.
scientia non olet · About LEMON Manuals