Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Caliper Bracket

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper bracket (1).

Fig 2: Brake Caliper Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the brake caliper bracket bolts (1) and tighten to 190 N.m (140 lb ft).

Fig 3: Brake Pad Springs

Courtesy of GENERAL MOTORS CORP.

Install the brake pad springs (1).

Fig 4: Inner & Outer Brake Pads

Courtesy of GENERAL MOTORS CORP.

NOTE: Note the location of the wear sensor for correct installation.

Install the inner brake pad (1).
Install the outer brake pad (2).
Position the brake caliper to the bracket.

Fig 5: Brake Caliper Guide Pin Bolts

Courtesy of GENERAL MOTORS CORP.

Hold the brake caliper guide pins stationary and tighten the brake caliper guide pin bolts (1) to 27 N.m (20 lb ft).
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .