LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo, 6.6 L >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Accelerator Pedal Assembly
    GM1848812Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the accelerator pedal assembly.
  2. Install the accelerator pedal nuts and tighten to 20 N.m (15 lb ft) .
    3. Fig 2: Accelerator Pedal Position Sensor Electrical Connector
    GM858238Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector.
  4. Reposition the carpet.
  5. Install the CPA retainer.
  6. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  7. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle and a wide open throttle (WOT).
  8. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  9. Inspect the carpet fit under the accelerator pedal.
scientia non olet · About LEMON Manuals