LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Lighting System) >> Diagnostic Information and Procedures >> DTC B3884 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X5 harness connector at the BCM.
  2. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 5 and ground.
    • If the test lamp illuminates, test the control circuit for a short to voltage.
  3. Ignition ON, connect a 3A fused jumper wire between the control circuit terminal 5 and B+. Verify the auxiliary stop lamps illuminate.
    • If the stop lamps do not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the underhood fuse block.
  4. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals