LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: CKP Sensor And Bolt
    GM1336119Courtesy of GENERAL MOTORS CORP.
    NOTE:

    The crankshaft position sensor spacers are machined with different timing positions. However, if the crankshaft position sensor spacer requires replacement, replace with a grade "C" spacer.

  1. If necessary, lubricate a NEW CKP spacer O-ring with clean engine oil.
  2. If necessary, install the NEW O-ring to the CKP sensor spacer.
  3. If necessary, install the CKP sensor spacer.
    4. CAUTION:

    Refer to Fastener Caution .

  4. If necessary, install the CKP sensor spacer bolts and tighten to 10 N.m (89 lb in).
  5. Install the CKP sensor.
  6. Install the CKP sensor bolt and tighten to 10 N.m (89 lb in) .
    7. Fig 2: Crankshaft Position Sensor Electrical Connector
    GM1335470Courtesy of GENERAL MOTORS CORP.
  7. Connect the CKP sensor electrical connector.
  8. Lower the vehicle.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals