LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Caprice >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Front Impact Sensor Electrical Connections
    GM2054401Courtesy of GENERAL MOTORS CORP.
  1. Install the front impact sensor electrical connections (1).
    2. NOTE:

    Locating lugs will hold the NEW sensors in place.

  2. Install the NEW front impact sensors (2) to the front end module (3).
    3. Fig 2: Identifying Right Front Impact Sensor To Front End Module Retaining Bolt
    GM2049915Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  3. Install the right front impact sensor to front end module retaining bolt (1) and tighten to 9 N.m (80 lb in).
    4. Fig 3: Identifying Left Front Impact Sensor To Front End Module Retaining Bolt
    GM2049913Courtesy of GENERAL MOTORS CORP.
    NOTE:

    The radiator top mounts can be taken off and the radiator lent back to aid in installation.

  4. Install the left front impact sensor to front end module retaining bolt (1) and tighten to 9 N.m (80 lb in).
  5. Enable the SIR. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals