Sunroof Motor/Actuator Initialization/Teach Process (New Motor)

WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

Perform the Initialization/Teach Process any time a new sunroof motor actuator is installed in the vehicle.

Ensure that the electrical harness on the headliner is connected to the sunroof motor.
Put the ignition in the RUN position.
Re-initialization (Normalization), press "Manual Close Switch" until the sunroof window reaches the Close Position or stops moving.
Release the switch.
Press "Manual Close Switch" for more than 10 seconds until the sunroof window starts and reaches the hard stop.
Verify the operation of the sunroof.

NOTE: The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:

The sunroof switch is not held in the close position.
The ignition and/or battery power has been removed.
The glass panel has not reached the closed position.

The Initialization/Teach Process must be restarted if the procedure is not carried out completely.