Component Testing
- Disconnect the harness connector at the turn signal/multifunction switch.
- Cruise control switch ON, measure the resistance between terminal 5 and terminal 6 while individually activating and holding each cruise control function switch and compare the resistance reading to the values in the table below.
- If not within the specified resistance range, replace the turn signal/multifunction switch.
| Function Switch | Minimum Resistance Value | Maximum Resistance Value |
|---|---|---|
| Off | 6.7k Ohms | 6.9k Ohms |
| On | 1.4k Ohms | 1.6k Ohms |
| - SET | 2.2k Ohms | 2.4k Ohms |
| + RES | 3.6k Ohms | 3.9k Ohms |