LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Caprice >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 6.0L - DTC Diagnostics And Troubleshooting >> Diagnostic Information and Procedures >> DTC P2534 (Fuel Pump Control Module) >> Circuit/System Testing

Circuit/System Testing

  1. Verify that DTC P0562 is not set.
  2. Ignition OFF, disconnect the harness connector of the K27 fuel pump control module.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 21 and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the K27 fuel pump control module.
scientia non olet · About LEMON Manuals