LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Camaro LS, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: Battery Positive Cable Components
    GM2185665Courtesy of GENERAL MOTORS CORP.
  2. Remove the junction block cover (4).
  3. Remove the junction block nut (3).
  4. Remove the positive battery to starter cable from the junction block terminal (1).
  5. Remove the positive battery cable (2).
  6. Disengage all remaining cable retainers under the hood.
  7. Remove the floor console. Refer to Front Floor Console Replacement .
  8. Remove rear seat lower cushion. Refer to Rear Seat Cushion Replacement .
  9. Remove left side quarter trim panel. Refer to Quarter Trim Panel Replacement .
  10. Reposition rear compartment side trim panel as required.
    11. Fig 2: Pass-Through Grommet & Cable Retainers
    GM2185663Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the pass-through grommet (1) from the floor plenum.
  12. Disconnect cable retainers (2) from the floor plenum.
    13. Fig 3: Battery Positive Cable Retainers
    GM2185662Courtesy of GENERAL MOTORS CORP.
  13. Working through the openings in the floor carpet, disconnect all remaining retainers (1).
  14. Pull the battery positive cable through the carpet. Note the cable routing for installation purposes.
    15. Fig 4: Battery Positive Cable & Terminal Nut
    GM2185659Courtesy of GENERAL MOTORS CORP.
  15. Loosen the battery terminal nut (2).
  16. Open the positive battery cable terminal cover.
  17. Remove the battery positive terminal.
  18. Pull the positive battery cable (1) from the passenger compartment into the trunk area.
scientia non olet · About LEMON Manuals