Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the EBCM.
- Test for less than 5 Ω between the ground circuits listed below and ground:
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground:
- Terminal 1
- Terminal 14
- Terminal 20
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the brake pressure modulator valve and EBCM assembly.