Installation Procedure
WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Install the differential clutch assembly, if removed. Refer to Differential Clutch Replacement
- Using the hydraulic jack stand, position the rear differential assembly (1) in the vehicle.
- Clean the bolts and apply thread locker on the threads. Refer to Adhesives, Fluids, Lubricants, and Sealers
- Install the front differential mounting bolts (1) and tighten to 40 N.m (30 lb ft) + 90 degrees.
- Install the rear differential assembly mounting bolts (1) and tighten to 40 N.m (30 lb ft) + 90 degrees.
- Remove the hydraulic jack stand.
- Install the wheel drive shafts. Refer to Rear Wheel Drive Shaft Replacement .
- Install the electronic park brake control module. Refer to Electronic Parking Brake Control Module Replacement .
- Reconnect the electrical connectors from the rear differential assembly to the chassis.
- Install the exhaust muffler assembly. Refer to Exhaust Muffler Replacement (LF1) or Exhaust Muffler Replacement (LAU) .
- Install the propeller shaft assembly. Refer to Propeller Shaft Replacement .
- Check the fluid level of the rear differential assembly. Refer to Differential Clutch Oil Inspection and Rear Axle Lubricant Level Inspection .
- If installing a NEW rear differential assembly, fill with the proper fluid. Refer to Differential Clutch Oil Replacement and Differential Oil Replacement .
- Remove the supports and lower the vehicle.
CAUTION:
Refer to Fastener Caution
.