Video Display Replacement (U42)

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Video Display & Screws (U42)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Video Display Assembly Screw (Qty: 4) CAUTION: Refer to Fastener Caution . Procedure: Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded. Tighten: 2 N.m (18 lb in)
2	Video Display Assembly Procedure Pull down to disengage the retainer clip and remove from the vehicle. Disconnect the electrical connector.

Callout

Component Name

Video Display Assembly Screw (Qty: 4)

CAUTION: Refer to Fastener Caution .

Procedure:
Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.

Tighten: 2 N.m (18 lb in)

Video Display Assembly

Procedure

Pull down to disengage the retainer clip and remove from the vehicle.
Disconnect the electrical connector.