LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> StabiliTrak Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the traction control switch.
  2. Test for less than 1 ohm between the ground circuit terminal 3 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Traction Control Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 1 for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal 1 and the ground circuit terminal 3. Verify the scan tool Traction Control Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the traction control switch.
scientia non olet · About LEMON Manuals