Driver Window Switch
- Ignition OFF, disconnect theX1 and X2 harness connectors at the driver window switch.
- Test for less than 2 ohms between the lockout control terminal F and the B+ terminal E with the lockout switch in the ENABLE position.
- If greater than the specified value, replace the driver window switch.
- Test for infinite resistance between the lockout control terminal F and the B+ terminal E with the lockout switch in the DISABLE position.
- If less than the specified value, replace the driver window switch.
- With the switch in the INACTIVE position, test for infinite resistance between the appropriate signal and control terminals and the B+ terminal E listed below:
- Control terminal A
- Signal terminal B
- Signal terminal C
- Signal terminal D
- Control terminal E
- Signal terminal G
- Signal terminal H
- If less than the specified value, replace the driver window switch.
- With the switch in the UP position, test for less than 2 ohms between the control terminals and the B+ terminal E listed below:
- Signal terminal D
- Signal terminal G
- Signal terminal B
- Control terminal E
- If greater than the specified range, replace the driver window switch.
- With the switch in the DOWN position, test for less than 2 ohms between the control terminals and the B+ terminal E listed below:
- Signal terminal C
- Signal terminal H
- Signal terminal C
- Control terminal A
- If greater than the specified range, replace the driver window switch.