LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 286 (Engine Controls And Fuel - 2.9L - Repair Instructions) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of ECM
    GM1352004Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM into the ECM mounting bracket, allowing the tabs to fully engage.
    2. Fig 2: View Of ECM/PCM & ECM/PCM Harness Connectors
    GM1350711Courtesy of GENERAL MOTORS CORP.
  2. Connect the ECM harness connectors (2) to the ECM body (3).
  3. If a new ECM is being installed, the ECM must be programmed. Refer to Control Module References .
  4. If equipped with a manual transmission, perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .
scientia non olet · About LEMON Manuals