LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Equinox LS, FWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: EBCM
    GM1873923Courtesy of GENERAL MOTORS CORP.
  1. Install the EBCM seals, if removed.
  2. Install the EBCM (1) to the BPMV.
    3. Fig 2: EBCM Bolts
    GM1873922Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the 4 EBCM bolts (1) and tighten the bolts in a cross pattern to 3 N.m (27 lb in).
  4. Install the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .
  5. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  6. Without starting the engine, place the ignition switch in the ON position.
  7. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals