LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Equinox LS, FWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> Traction Control/Stability Control Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

NOTE: Circuit/System Verification must be performed before Circuit/System Testing.
  1. Ignition OFF, disconnect the harness connector at the S48C Multi-Function Switch - Instrument Panel 1.
  2. Test for less than 5 Ω between the ground circuit terminal 1 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool BCM Traction Control Switch parameter is Inactive.
    • If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K9 Body Control Module.
  4. Install a 3A fused jumper wire between the signal circuit terminal 3 and ground.
  5. Verify the scan tool BCM Traction Control Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
  6. If all circuits test normal, test or replace the S48C Multi-Function Switch - Instrument Panel 1.
scientia non olet · About LEMON Manuals