LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Sky and 2010 Pontiac Solstice. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating ECM
    GM1828317Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine wiring harness electrical connectors (1, 3) to the ECM (2).
    2. Fig 2: Identifying Upper & Lower ECM Retaining Tabs
    GM1828318Courtesy of GENERAL MOTORS CORP.
  2. Slide the ECM into the bracket.
  3. Push down on the ECM until the upper and lower retaining tabs (1, 2) snaps into place.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Install the windshield washer solvent container. Refer to Windshield Washer Solvent Container Replacement (Solstice) or Windshield Washer Solvent Container Replacement (SKY) .
  6. Install the left front fender. Refer to Front Fender Replacement .
  7. Reset the clock and preset radio stations.
  8. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References .
  9. If equipped with a manual transmission, perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .
scientia non olet · About LEMON Manuals