LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1898 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> Passenger Presence System Preload Test >> Passenger Presence System Preload System Test Procedure (Existing Module)

Passenger Presence System Preload System Test Procedure (Existing Module)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Savana Special, 2011 GMC Savana Camper Special, 2011 GMC Savana, 2011 Chevrolet RV Cutaway, and 2011 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With Service Programming System (SPS) , unlock the passenger presence module.
  2. Empty the front outboard passenger seat.
  3. With the scan tool, perform the Passenger Presence Sensor Learn procedure.
  4. If the test fails, adjust the seat bottom trim, and massage the cover to ensure unwanted pressure is not present in the specified area, and restart the Passenger Presence System Preload Test (Existing Module) with step 1.
  5. Once the test successfully completes, cycle the ignition key OFF.
  6. Perform the Diagnostic System Check - Vehicle after successfully completing the preload test procedure to ensure the system is functioning properly.
scientia non olet · About LEMON Manuals