Front Toe Adjustment
- Remove the power steering gear seal small clamps.
- Verify that the steering wheel is centered and the wheels are in the straight ahead position.
- Loosen the left and right tie rod jam nuts (2).
- Rotate the inner tie rods in order to obtain the proper toe angle of 0 degrees.
- Install the left and right tie rod jam nuts (2) and tighten to 68 N.m (50 lb ft).
- Install the power steering gear seal small clamps.
NOTE:
Verify that the number of threads showing on both inner tie rod ends are approximately equal.
CAUTION:
Refer to Fastener Caution
.
NOTE:
Verify that the power steering gear seal is not twisted.