Radio Replacement

Fig 1: Identifying Radio

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Acadia) or Instrument Panel Accessory Trim Plate Replacement (Enclave) or Instrument Panel Accessory Trim Plate Replacement (OUTLOOK) or Instrument Panel Accessory Trim Plate Replacement (Traverse) .
1	Radio Screw (Qty: 4) CAUTION: Refer to Component Fastener Tightening Caution . Tighten: 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References . Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Radio Screw (Qty: 4)

CAUTION: Refer to Component Fastener Tightening Caution .

Tighten: 2.5 N.m (22 lb in)

Radio Assembly

Procedure

Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.