LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Diagnostic Information and Procedures >> Steering Column Tilt/Telescoping Inoperative >> Component Testing >> Tilt/Telescope Switch

Tilt/Telescope Switch

  1. Ignition OFF, disconnect the harness connector at the tilt/telescope switch.
  2. Test for infinite resistance between the following terminals with the switch in the neutral position:
    • B+ terminal 1 and signal terminal 5
    • B+ terminal 1 and signal terminal 6
    • B+ terminal 1 and signal terminal 2
    • B+ terminal 1 and signal terminal 3
    • If less than the specified range, replace the steering column.
  3. Test for less than 1 ohm or resistance between the B+ terminal 1 and the signal terminal 2 with the switch in the TILT UP position.
    • If greater than the specified range, replace the steering column.
  4. Test for less than 1 ohm between the B+ terminal 1 and the signal terminal 6 with the switch in the TILT DOWN position.
    • If greater than the specified range, replace the steering column.
  5. Test for less than 1 ohm or resistance between the B+ terminal 1 and the signal terminal 5 with the switch in the TELESCOPE OUT position.
    • If greater than the specified range, replace the steering column.
  6. Test for less than 1 ohm or resistance between the B+ terminal 1 and the signal terminal 3 with the switch in the TELESCOPE IN position.
    • If greater than the specified range, replace the steering column.
scientia non olet · About LEMON Manuals