LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new wheel stud from the back side of the bearing/hub.
    2. Fig 1: Identifying Washers, Wheel Stud & Hex Nut
    GM65317Courtesy of GENERAL MOTORS CORP.
  2. Install 3 flat washers (1) to the wheel stud (3).
  3. Install a hex nut (2) to the wheel stud (3).
    4. Fig 2: Seating Stud Head Fully In Bearing/Hub Flange
    GM175950Courtesy of GENERAL MOTORS CORP.
  4. Tighten the hex nut until the stud head is fully seated in the bearing/hub flange.
  5. Remove the hex nut and the washers from the wheel stud.
  6. Install the brake rotor. Refer to Front Brake Rotor Replacement .
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals