LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the outer tie rod end from the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  4. Turn the knuckle to the left.
  5. Using the proper size Allen wrench and a wrench, loosen the lower ball joint nut.
    6. Fig 1: Identifying J 42188 Ball Joint Separator
    GM2001931Courtesy of GENERAL MOTORS CORP.
  6. Using the J 42188:  separator (1), disconnect the lower ball joint from the knuckle.
    7. Fig 2: Identifying Ball Joint Mounting Nut
    GM1853193Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower ball joint nut.
    8. Fig 3: Identifying Control Arm Mounting Bolt And Nut
    GM1853070Courtesy of GENERAL MOTORS CORP.
  8. Remove the front lower control arm front nut (4) from the stud (3).
  9. Remove the lower control arm rear nut (2) and bolt (1).
    10. Fig 4: Identifying Lower Control Arm
    GM1853091Courtesy of GENERAL MOTORS CORP.
  10. Remove the front lower control arm from the vehicle.
scientia non olet · About LEMON Manuals