Installation Procedure
WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bushing (2) on the stabilizer shaft (1).
- Maneuver the stabilizer shaft in such away to properly install it on the frame.
- Install the stabilizer shaft (1) on the stabilizer shaft link (2).
- Install the stabilizer shaft clamp (2) and the bolts (1).
- Install the bushing (2) and the upper stabilizer shaft link retaining nut with washer (1).
- Insert a wrench (1) on the stabilizer shaft link (2) so as not to allow the stabilizer shaft link to rotate when removing or installing the retaining nut.
- Tighten the upper stabilizer shaft link retaining nut.
Tighten: Tighten the retaining nut to 22 N.m (16 lb ft).
- Tighten the stabilizer shaft clamp bolts.
Tighten: Tighten the clamp bolts nut to 50 N.m (16 lb ft).
- Install the spare tire.
- Install the rear tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Remove the support and lower the vehicle.
NOTE:
In steps 4 and 5, DO NOT tighten the bolts or nuts to specifications. Leave the bolts and nut loose.
CAUTION:
Refer to Fastener Caution
.