LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Junction Block Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Battery Positive Junction Block Cable
    GM1861224Courtesy of GENERAL MOTORS CORP.
  1. Install the battery positive junction block cable to the vehicle.
    2. Fig 2: Identifying Accessory Wiring Junction Block Cover & Nut
    GM1861038Courtesy of GENERAL MOTORS CORP.
  2. Install the battery positive junction block cable terminal (4) to the stud.
  3. Install the positive battery cable terminal (3) to the junction block stud.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the accessory wiring junction block nut (2).

    Tighten:  Tighten the nut to 22 N.m (16 lb ft).

  5. Close the accessory wiring junction block cover (1).
    6. Fig 3: Identifying Battery Positive Junction Block Cable Clips
    GM1861223Courtesy of GENERAL MOTORS CORP.
  6. Install the battery positive junction block cable clips (1) to the power steering reservoir bracket.
    7. Fig 4: Identifying Battery Positive Junction Block Cable Boot & Cable Terminal
    GM1861163Courtesy of GENERAL MOTORS CORP.
  7. Install the battery positive junction block cable terminal (3) to the generator stud.
  8. Install the battery positive junction block cable to generator nut (3).

    Tighten:  Tighten the nut to 22 N.m (16 lb ft).

  9. Position the battery positive junction block cable boot (1).
  10. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    11. Fig 5: View Of Battery Positive Junction Block Cable Clip & Cable Terminal
    GM1861148Courtesy of GENERAL MOTORS CORP.
  11. Install the battery positive junction block cable terminal (2) to the starter.
  12. Install the starter solenoid BAT terminal nut (3).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  13. Install the battery positive junction block cable clip (1) to the engine block.
    14. Fig 6: Identifying Starter Heat Shield Bolt & Shield
    GM1861146Courtesy of GENERAL MOTORS CORP.
  14. Install the starter heat shield and bolt.

    Tighten:  Tighten the bolt to 7 N.m (62 lb in).

  15. Install the left catalytic converter. Refer to Catalytic Converter Replacement - Left Side .
  16. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
  17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals