LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Control System & Fuel System - 3.6L - Repair Instructions) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of ECT Sensor
    GM1836047Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the ECT sensor.

    Tighten:  Tighten the sensor to 22 N.m (16 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1858010Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (8) to the ECT sensor (9).
  3. Slide the electrical connector heat shield down over the connector.
  4. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac N Fill) .
scientia non olet · About LEMON Manuals