LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Front Suspension System) >> Repair Instructions >> Front Lower Control Arm Rear Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front & Rear Bushings
    GM1853577Courtesy of GENERAL MOTORS CORP.
  1. Position the front and rear bushings so that they are equally in the control arm.
  2. Position the CH-48107  Bushing Remover and Installer on the front bushing.
  3. Using the vise, compress the front and rear bushings until they are seated.
  4. Remove the lower control arm from the vise.
  5. Remove the CH-48107  Bushing Remover and Installer from the front bushing.
  6. Install the lower control arm in the vehicle. Refer to Lower Control Arm Replacement .
scientia non olet · About LEMON Manuals