LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P0622 >> Circuit/System Testing

Circuit/System Testing

  1. Verify that a test lamp illuminates between the B+ circuit ring terminal 1 X2 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  2. Ignition OFF, disconnect the X1 harness connector at the generator.
  3. Ignition ON, verify the scan tool ECM GEN-F Terminal Signal is less than 5%.
    • If greater than the specified range, test the signal circuit terminal 2 X1 for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 2 X1 and B+. Verify the scan tool ECM GEN-F Terminal Signal is greater than 95%.
    • If less than the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the generator.
scientia non olet · About LEMON Manuals