Component Testing

Relay Test

1. Ignition OFF, disconnect the RUN/CRANK relay.
2. Test for 60-180 ohms between terminals 85 and 86.
   • If the resistance is not within the specified range, replace the relay.
3. Test for infinite resistance between the following terminals:
   • 30 and 86
   • 30 and 87
   • 30 and 85
   • 85 and 87
   • If less than infinite resistance, replace the RUN/CRANK relay.
4. Install a 20-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2.0 ohms between terminals 30 and 87.
   • If greater than 2.0 ohms, replace the RUN/CRANK relay.