LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - DTC P0638 To DTC P2635 >> DTC P0641 or P06A6 (FPCM) >> Circuit/System Testing (FPCM)

Circuit/System Testing (FPCM)

  1. Ignition OFF, disconnect the harness connector at the fuel line pressure sensor.
  2. Ignition OFF, test for less than 1.0 ohm between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the FPCM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the FPCM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the FPCM.
  4. If all circuits test normal, replace the fuel pressure sensor.
scientia non olet · About LEMON Manuals