LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis (Single Page) >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> Charging System Test (OUTLOOK) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition ON, verify that no generator or battery current sensor DTCs are set that would cause a charging system concern.
  2. Engine OFF, connect the SA9154Z-A  Starting System Tester red lead to the battery positive terminal and the grey lead to the output circuit of the generator. See Special Tools .
  3. Engine ON, turn ON the SA9154Z-A  Starting System Tester. See Special Tools . Turn all vehicle accessories OFF and follow all the prompts.
  4. Press the CHARGING SYSTEM TEST button. The display should read 13.0 - 15.5 volts.
    • If not within specified range, replace the generator.
  5. Is the generator output current greater than or equal to the load test output value given in Generator Usage  ?
    • If not within specified value, replace the generator.
scientia non olet · About LEMON Manuals