Component Testing
Ignition Switch
- Ignition OFF, disconnect the harness connector at the ignition switch.
- Verify the resistance between the terminals listed below match for each ignition switch position.
- If not the specified value, replace the ignition switch.
Resistance Test
| Ignition Switch Position | Terminals 1 and 2 | Terminals 2 and 3 | Terminals 2 and 4 | Terminals 2 and 6 | Terminals 4 and 6 |
|---|---|---|---|---|---|
| Off Key Out | Infinite | Infinite | Infinite | Infinite | Infinite |
| Off Key IN | Infinite | Infinite | < 5.0 ohms | Infinite | Infinite |
| Accessory | Infinite | < 5.0 ohms | Infinite | Infinite | Infinite |
| Run | < 5.0 ohms | < 5.0 ohms | Infinite | Infinite | < 5.0 ohms |
| Start | < 5.0 ohms | Infinite | Infinite | Infinite | 1275-1325 ohms |