LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Diagnostic Information and Procedures >> Windshield Wiper Washer System Malfunction >> Circuit/System Testing >> Windshield Wiper/Washer Switch Circuit Malfunction

Windshield Wiper/Washer Switch Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the Windshield Wiper/Washer switch.
  2. Ignition ON, test for 12 volts between accessory voltage circuit terminal D and ground.
    • If not the specified value, test the accessory voltage circuit terminal D for a short to ground. If the circuit tests normal, replace the BCM.
  3. Ignition ON, verify the scan tool Windshield Washer Switch parameter is Inactive.
    • If not the specified value, test the control circuit terminal B for a short to B+. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the control circuit terminal B and B+. Verify the scan tool Windshield Washer Switch parameter is Active.
    • If not the specified value, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the Windshield Wiper/Washer switch.
scientia non olet · About LEMON Manuals