LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> TrailBlazer 4.2 S, RWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Fixed & MOVEABLE Window System >> Repair Instructions >> Front Side Door Window Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Remove/Load Position & Window Fully Secure Position (Front Door)
    GM723036Courtesy of GENERAL MOTORS CORP.
  1. Install the window to the door with the regulator adjusted to the remove/load position (2).
  2. Tilt the window forward and carefully guide the window into the rear run channel.
  3. Position the window to an upright position. Ensure that the window is seated into the run channels.
  4. Lower and position the window into the regulator clamps at the alignment marks previously made.
  5. Loosely tighten the regulator clamp bolts.
    6. NOTE: Do not operate the regulator motor without supporting the window. Ensure that the window remains in the run channels when operating the regulator motor.
  6. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the run channels.
  7. Position the window to a fully secure position (1) into the upper door weatherstrip.
    8. CAUTION: Refer to Fastener Caution .
  8. Tighten the 2 regulator clamp nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

  9. Install the outer belt sealing strip. Refer to Front Side Door Window Belt Outer Sealing Strip Replacement .
  10. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  11. Install the door speaker. Refer to Radio Front Side Door Speaker Replacement .
  12. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals