LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Malibu Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Buick LaCrosse and 2009 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing MAP & BARO Sensors Retaining Clips
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Install the BARO sensor.
  2. Install the BARO sensor retainer.
  3. Connect the BARO sensor electrical connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals