LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Engine Cooling System) >> Repair Instructions >> Auxiliary Engine Oil Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil cooler/power steering cooler to the vehicle.
    Fig 1: Locating Engine Oil Cooler/Power Steering Cooler Bolts
    GM1247672Courtesy of GENERAL MOTORS CORP.
  2. Install the upper bolt (1) to the engine oil cooler/power steering cooler bracket.

    Tighten:  Tighten the bolt to 2 N.m (18 lb in).

    NOTE: Refer to Fastener Notice .
  3. Install the lower bolts (2) to the engine oil cooler/power steering cooler bracket.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  4. Install the engine oil cooler lines to the engine oil cooler. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .
  5. Install the power steering oil cooler lines to the power steering cooler.
  6. Reposition the hose clamps on the power steering cooler lines.
  7. Install the support clip to the engine oil cooler lines.
  8. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine (Right) or Splash Shield Replacement - Engine (Left) .
  9. Install the lower air baffle. Refer to Radiator Air Lower Baffle and Deflector Replacement .
  10. Install the upper air baffle. Refer to Radiator Air Upper Baffle and Deflector Replacement .
  11. Add the proper amount of engine oil and power steering fluid.
scientia non olet · About LEMON Manuals