Turn Signal/Multifunction Switch
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector C1 at the turn signal/multifunction switch.
- Test for infinite resistance between the following terminals and the ground circuit terminal E with the switch in the neutral position.
- Signal terminal D
- Signal terminal F
- If not the specified value, replace the turn signal/multifunction switch.
- Test for less than 2.0 ohms of resistance between the signal circuit terminal D and the ground circuit terminal E with the switch in the left turn position.
- If greater than the specified range, replace the turn signal/multifunction switch.
- Test for less than 2.0 ohms of resistance between the signal circuit terminal F and the ground circuit terminal E with the switch in the left turn position.
- If greater than the specified range, replace the turn signal/multifunction switch.