LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Key Alarm Connector To/From Ignition Lock Cylinder Case
    GM324871Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  2. Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).
    3. Fig 2: Disconnecting/Reconnecting Theft Deterrent Control Module Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  3. Connect the theft deterrent control module connector.
  4. Connect the fused jumper assembly connector.
    5. Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  5. Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals